Audiovox AFX-35.00 Manual de instalación descargar pdf

Model APS-155

Installation Manual

SELECTABLE FEATURES

Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin

switch in order to begin the passive arming sequence.

RF Programmable Features :

Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps Default

1st Door L/UL 1 Sec. 3.5 Sec. 1 Sec L, Dbl. U/L 1 Sec.

2nd Accy Lock Auto Lock On Auto Lock Off Auto Lock Off

3rd Accy. UL Auto UL On Auto UL Off Auto UL Off

4th Passive Locks Passive Active Active

5th Passive/Active Arm Passive Arm Active Arm Active Arm

6th Voltage Sense Voltage Sense Hardwire Hardwire

7th Siren/Horn Siren/Horn Siren Only Horn Only Siren/Horn

8th Horn Chirp 10mS 16mS 30mS 16mS

9th Override Method Custom Code Valet Valet

10th Chirp Delete From Tx On Off Off

To program these selectable features;

Action System Response

Turn ignition on No response

Press and release the valet switch 3 times 1 Chirp - LED 1 flash

Within 3 seconds, turn ignition Off Short chirp, then long chirp

First Then On 1 chirp = 1 second door locks

Press transmitter Lock button to change 2 chirps = 3.5 second door locks

Press transmitter Lock button to change 3 chirps = 1 sec. lock, dbl 1 sec. unlock

Second Press and release the valet switch 2 chirps = auto locks off

Press transmitter Lock button to change 1 chirp = auto locks on

Third Press and release the valet switch 2 chirps = auto unlock off

Press transmitter Lock button to change 1 chirp = auto unlock on

Fourth Press and release the valet switch 2 chirps = active locks

Press transmitter Lock button to change 1 chirp = passive locks

Fifth Press and release the valet switch 2 chirps = active arming

Press transmitter Lock button to change 1 chirp = passive arming

Sixth Press and release the valet switch 2 chirps = hardwire

Press transmitter Lock button to change 1 chirp = voltage sense

1 2 3 4 5 6

Model APS-155 1
128-5733A 6

Indice de contenidos

Pagina 1 - Model APS-155

Model APS-155Installation ManualSELECTABLE FEATURESNote : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s do

Pagina 2

Page 2INSTALLATION OF MAJOR COMPONENTSControl Module :Select a mounting location inside the passenger compartment ( up behind the dash ), and secure u

Pagina 3

Page 3an even higher level of security to the vehicle.The valet switch can be mounted to the lower side of the dash by drilling a ¼ “ diameter hole in

Pagina 4

Page 4Brown Wire : - DOOR TRIGGERIf the vehicle’s courtesy light switches have a ( - ) ground output when the door is opened ( GM and mostImports ), y

Pagina 5

Page 5Red & Green 2 Pin White Connector : DOOR LOCK OUTPUTSThese wires will provide either a pulsed ground output to the factory door lock control

Pagina 6 - 128-5733A