Audiovox PRO9776C Manual de usuario descargar pdf (Pagina 13)

128-8786b

13 of 16

Page 13

PROGRAMMED TRANSMITTER NOTIFICATION (PTN)

Every time after Disarm when the ignition key is turned on, the unit's LED will report the

number of transmitters programmed into the system. This safety feature will alert you if

an unauthorized transmitter has been programmed into your vehicle's security system

without your knowledge. Typical from the factory, there will be a 2 flash, pause, repeated

3 times indicating that two transmitters are programmed into the system. If you note

additional flashes, there may heve been an additional transmitter added without your

knowledge or authorization. If you notice a change in the transmitter LED report pattern,

you can correct this by looking up how to erase and reprogram your transmitters found

in the transmitter programming guide. This reprogram operation will erase all unauthorized

or unwanted transmitters.

PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1)

The Transmitter Model Name Is Found On Back Of Transmitter Case

1. Turn the ignition key to the on position.

2. Press and release the valet/programming switch 3 times (Siren Chirps).

3. Press the Lock Button of each transmitter you want programmed until you hear

a chirp from the horn or siren.

4. Turn the ignition switch off.

The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons

which are typical for most systems.

For additional channel programming beyond the option 1 button, you can use any

unused button or combination of buttons not in use.

In other words, to access option channel 5, 6, 7, you would do the following:

From step 3 above:

a. Press and release the valet/programming button 4 additional times to get to

channel 5, then Press any unused transmitter button or button combination to

program.

b. From a, press and release the valet/programming button 1 time to get to

channel 6, then press any unused transmitter button or button combination to

program.

c. From b, press and release the valet/programming button 1 time to get to

channel 7, then press any unused transmitter button or button combination to

program.

NOTE: Not all systems have channels above 3, check with your installation center

for options your system may or may not have.

1 2 ... 8 9 10 11 12 13 14 15 16

Sin comentarios

Audiovox PRO9776C Manual de usuario Pagina 13