Audiovox PRO 9644aUGH Manual de usuario descargar pdf (Pagina 9)

Transitioning into Lot Mode

1. Turn the ignition ON.

2. Press and release the override button 3 times.

3. The system will chirp 1 time.

4. Press button 1 of the short range transmitter.

5. The system will respond with 1 chirp.

6. Turn the ignition OFF to exit transmitter programming.

7. The system will chirp 2 times to confirm exit.

Note: This system has 1 button programming which programs all channels of the transmitter to the

system at once.

When in lot mode, a consumer remote can not be programmed to the system until it is transitioned to

consumer mode.

All programming features will be defaulted to the factory default settings.

TRANSITIONING BETWEEN MODES - SHORT RANGE TRANSMITTER

Transitioning into Consumer Mode

1. Open a vehicle door.

2. Press and hold button 2 of the short range transmitter until the system chirps 3 times.

3. Again press and hold button 2 of the short range transmitter until the system chirps 3 times.

4. Within 5 seconds program a consumer remote. If no remotes are programmed in the 5 second

window, the system will default to a factory keyless upgrade setting which uses the factory remote

controls to arm and disarm the system.

Note: Programming features 1-4 will be defaulted to the factory default settings, programming features

5-13 will retain any changes that have been made.

ON BOARD SHOCK SENSOR

Adjusting the Shock Sensor

1. Increase sensitivity by turning the adjustment dial clockwise.

2. Decrease sensitivity by turning the adjustment dial counter clockwise.

Testing the Shock Sensor

Arm the system and wait 6 seconds for the zone to stabilize, then firmly strike the vehicles bumper.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Sin comentarios

Audiovox PRO 9644aUGH Manual de usuario Pagina 9